the motion control company
(888) 777-1826
+1 (818) 222-9200
Home About Us Videos Site Map Contact Us
Products
Motion Controllers
Linear/ Rotary Actuators and Stages
Motors -  Stepper, Servo
Motor Drivers - Stepper, Servo
Solenoid Control Electronics
Power Supplies
Accessories
Knowledge Center
Motion Control Block Diagram
About Us
Site Map
Movies

Solenoid Electronics


Please use the following comparison table to find the product that meets your requirements.
Item Number Series Mode of Operation Controller Solenoid Driver Power Supply Number of Devices
1

 

Pick and Hold Module
 

 

Requires External Pulse Input
or
Self Triggered
- Yes - Up to 2

The Pick and Hold Solenoid Driver Module is designed to avoid over heating of the solenoid coil once it is energized.

Item Number Series Mode of Operation Controller Solenoid Driver Power Supply Number of Devices
2

 

Proportional (PWM) Module

 

 0-5 VDC Input Signal
or
4-20 milliamps Input Signal

or
External Potentiometer
or
Onboard Potentiometer
- Yes - Up to 2

The PWM Module is designed to enable the user to vary the voltage across a solenoid or other devices. The PWM output voltage is proportional to the input control voltage.

Item Number Series Mode of Operation Controller Solenoid Driver Power Supply Number of Devices
3

 

Closed Loop Solenoid Position Control Module

 

Step and Direction
or
Phase-A and Phase-B Quadratue Signals
or

0-5 VDC Input Signal
or
4-20 milliamps Input Signal

or
External Potentiometer
- Yes - Up to 2

This module offers a very low cost solution for limited angle / stroke position control.

The Closed Loop Solenoid Position Control Module is designed to control the position of a solenoid plunger / shaft, voice coil motor or similar devices.

Item Number Series Mode of Operation Controller Solenoid Driver Power Supply Number of Devices
4

 

Pick and Drop Module

 

Requires External Trigger Input
or
Onboard Potentiometer

 

- Yes - Up to 2

The Pick and Drop Solenoid Driver Module applies a single pulse to the device, then drops the supply voltage to zero.

Item Number Series Mode of Operation Controller Solenoid Driver Power Supply Number of Devices
5

 

Load On-Off Power Cycling Module

 

 Built-in Signal Generator
Yes, Limited Functionality Yes - Up to 2

The Load On-Off Cycling Module is designed to enable the user to cycle the voltage across a solenoid or other devices.

The frequency of actuation, the output peak voltage. and the duty cycle of the actuation (ratio of on time to the length of one full cycle) are adjusted using the onboard potentiometer.

Item Number Series Mode of Operation Controller Solenoid Driver Power Supply Number of Devices
6

 

 Dual Proportional Valve Controller

 

- Open Loop

- Closed Loop

- Yes - Up to 2

This module is designed for the open loop control of a pressure valve and closed loop control of a flow valve in a hydraulic system.

Item Number Series Mode of Operation Controller Solenoid Driver Power Supply Number of Devices
7

 

Solenoid Control System

 

Externally Controlled

Stand-alone

 

Yes Yes Yes Up to 32

The compact and stand-alone unit consists of controller,  solenoid drivers and the power supplies.


Home | Products | Accessories | Knowledge Center |About Us | Testimonials |Terms of Use | Videos |Site Map | Contact Us
                                             
Optimal Engineering Systems, Inc.
Los Angeles, California, USA

       Toll Free Number (888) 777-1826 in USA

+1 (818) 222-9200Sales%20-%20ControlofMotion.com
 

Sales - ControlofMotion.com

Copyright   1998 - 2014 Optimal Engineering Systems, Inc., All Rights Reserved