| |
Servo
Motor Controller and Driver
MCAD Series
|
|
Related Products
|
Features
-
Plug-and-Play
-
Runs DC Servo Motors
-
Quick and Easy to Install
- Very Compact and Easy to Use
- Low Power Consumption
- Easy Programming Language, No Compiler
or Assembler Required
Up to 10 Amp Motor Output
+7.5 VDC to +40 VDC Power Supply
PID Closed Loop Operation
Quadrature Encoder Feedback
Analog Feedback
- LED Fault Indicator
- Different Modes of Operation:
- Stand-alone, No PC Required to
Operate
- Host Controlled, PLC, C/C++, Visual
Basic, LabVIEW™, MATLAB™
Mechanical Specifications
|
|
Software
-
Easy System Setup and Evaluation
-
Menu Driven
-
Free Software Included
Dedicated Inputs
- Positive and Negative Limit Switches
- Home Switch
General Purpose Digital Input / Output
- 4 TTL /
CMOS Inputs
- 4 TTL / CMOS Outputs
General Purpose Analog Input
- 6 Inputs
-
10 Bits of
Resolution
Communication Interface
|
|
The MCAD series is a high performance, cost effective Servo Motor Controller and Driver to
implement intelligent Motion Control. The driver incorporates an advanced
architecture and surface mount technology to achieve an exceptional power
density.
This series of servo motor controller and driver is designed to drive
voice coil, brush-type and Linear DC (voice coil) motors.
This module is an
easy-to-use, plug-and-play
and
cost effective
solution for single-axis
servo motor
control applications.
It may be used as a stand-alone unit or may be commanded by an external
device.
The powerful programming instructions motion control, system configuration,
data flow, program flow commands, 32-bit logical and mathematical
operations, and other miscellaneous instructions.
The card may be
controlled in different ways;
1)
Stand-alone
In this mode, the controller does not need an external
device such as a PC to operate. The controller is programmed in a simple programming language. The code is developed,
downloaded to the controller, run and saved in the
controller's non-volatile memory using the supplied
Integrated Development Environment (IDE) software.
2)
Externally Controlled
In this mode, the external host such as a PC,
micro-controller or PLC sends a series of commands to
the controller via the RS-232 serial port. The controller
processes and performs the incoming commands and responds
with proper messages.
3)
Control Panel
The supplied user friendly Control Panel software allows the
user to set-up the module quickly. The operator is able to
move the mechanism to different positions by pressing the
corresponding buttons of the Control Panel.
|
|
|
Ordering Information
Part No. |
Description |
Amount |
MCAD-01 |
Single-axis,
Servo Motor Controller and Driver, up to +40 VDC
Power Supply |
Click to Get a Quote |
|