the motion control company
(888) 777-1826
+1 (818) 222-9200
Home About Us Videos Site Map Contact Us
Motion Controllers
Linear/ Rotary Actuators and Stages
Motors -  Stepper, Servo
Motor Drivers - Stepper, Servo
Solenoid Control Electronics
Power Supplies
Knowledge Center
Motion Control Block Diagram
About Us
Site Map

Variables, Mathematical and Logical Operations

The controller recognizes twenty two 32-bit variables, A through V. These variables may be used to receive, store and process numeric values. The range of the variables is from -2147483647 through +2147483647.

W, X, Y, and Z store the value of step counters. These values are read only and may not be written to.

The following operation may be performed on any two values or variables. 

+ Addition
/ Division
< Less Than
<= Less Than or Equal
& Logical AND
| Logical OR
# Logical XOR
% Modulo
> More Than
>= More Than or Equal
* Multiplication
<> Not Equal
~ Logical One’s Complement
() Parentheses
- Subtraction


Ask a Question


Home | Products | Accessories | Knowledge Center |About Us | Testimonials |Terms of Use | Videos |Site Map | Contact Us
Optimal Engineering Systems, Inc.
Los Angeles, California, USA

       Toll Free Number (888) 777-1826 in USA

+1 (818)

Sales -

Copyright   1998 - 2014 Optimal Engineering Systems, Inc., All Rights Reserved