the motion control company
(888) 777-1826
+1 (818) 222-9200
Home About Us Videos Site Map Contact Us
Products
Motion Controllers
Linear/ Rotary Actuators and Stages
Motors -  Stepper, Servo
Motor Drivers - Stepper, Servo
Solenoid Control Electronics
Power Supplies
Accessories
Knowledge Center
Motion Control Block Diagram
About Us
Site Map
Movies

How to Turn on or Turn off a Device


The control input of the device to be switched on or off should be connected to the output port of the controller. Please consult the Hardware Reference Manual for the location of the output port.

Please note that the output of the controller is CMOS with a voltage swing from 0 VDC to +5 VDC with +10 mAmp sink and source current capability. If this much current is not enough an external transistor or solid state relay may be used.

The motion controller has a set of commands to turn on / off its output lines individually or collectively. Please consult Operating and Programming Reference Manual.

Ask a Question

 


Home | Products | Accessories | Knowledge Center |About Us | Testimonials |Terms of Use | Videos |Site Map | Contact Us
                                             
Optimal Engineering Systems, Inc.
Los Angeles, California, USA

       Toll Free Number (888) 777-1826 in USA

+1 (818) 222-9200Sales%20-%20ControlofMotion.com
 

Sales - ControlofMotion.com

Copyright   1998 - 2014 Optimal Engineering Systems, Inc., All Rights Reserved