the motion control company
(888) 777-1826
+1 (818) 222-9200
Home About Us Videos Site Map Contact Us
Products
Motion Controllers
Linear/ Rotary Actuators and Stages
Motors -  Stepper, Servo
Motor Drivers - Stepper, Servo
Solenoid Control Electronics
Power Supplies
Accessories
Knowledge Center
Motion Control Block Diagram
About Us
Site Map
Movies

Modes of Operation


1) Stand-alone

In this mode, the motion controller does not need an external device such as a PC to operate. The controller is programmed in a simple programming language. The code is developed, downloaded to the controller, run and saved in the controller's non-volatile memory using the supplied Integrated Development Environment (IDE) software.

2) Externally Controlled

In this mode, the external host such as a PC, micro-motion controller or PLC sends a series of commands to the motion controller via the RS-232 serial port. The controller processes and performs the incoming commands and responds with proper messages.

3) Manual Mode

In this mode, the motion controller is operated using an analog joystick or a trackball. The speed of the motor is proportional to the tilt angle of the joystick or the rotational speed of the trackball.

 

Ask a Question


Home | Products | Accessories | Knowledge Center |About Us | Testimonials |Terms of Use | Videos |Site Map | Contact Us
                                             
Optimal Engineering Systems, Inc.
Los Angeles, California, USA

       Toll Free Number (888) 777-1826 in USA

+1 (818) 222-9200Sales%20-%20ControlofMotion.com
 

Sales - ControlofMotion.com

Copyright   1998 - 2014 Optimal Engineering Systems, Inc., All Rights Reserved