the motion control company
(888) 777-1826
+1 (818) 222-9200
Home About Us Videos Site Map Contact Us
Motion Controllers
Linear/ Rotary Actuators and Stages
Motors -  Stepper, Servo
Motor Drivers - Stepper, Servo
Solenoid Control Electronics
Power Supplies
Knowledge Center
Motion Control Block Diagram
About Us
Site Map

How to Read an Optical Encoder or a Quadrature Signal

The output of the optical encoder or the quadrature signals should be connected to the quadrature input port of the motion controller.
Please consult the Hardware Reference Manual for the location of the input port.

The motion controller has a set of commands to read the value of the decoded quadrature signals. Please consult Operating and Programming Reference Manual.

Ask a Question

Home | Products | Accessories | Knowledge Center |About Us | Testimonials |Terms of Use | Videos |Site Map | Contact Us
Optimal Engineering Systems, Inc.
Los Angeles, California, USA

       Toll Free Number (888) 777-1826 in USA

+1 (818)

Sales -

Copyright   1998 - 2014 Optimal Engineering Systems, Inc., All Rights Reserved